X-CELLMK2 COMBI-: SINEWAVE INVERTER \ BATTERY CHARGER SPECIFICATION
X-CELLMK2 COMBI-: SINEWAVE INVERTER \ BATTERY CHARGER SPECIFICATION
 |
 |
 |
 |
SPECIFICATION
MODEL:- 1500SL-12, [1500SL-24], 3000SL-12, [3000SL-24].
Nominal battery voltage
per model 12V [ 24V ]
Input voltage
range per model 9.5-16V [ 19-32V ]
Output voltage
200~240Vac.
Output frequency
50 Hz.
Total Harmonic
Distortion output THD < 2%.
Dynamic behaviour
0 - 100% 0.5 ms
Asymmetrical
load max. Up to nominal output power
Overload and
short circuit protection Automatic disconnection with 5 time restart attempt
Overheating temperature
protection Acoustic warning before shut-off. Automatic restart
Power factor
range 0.1-1
Power saving
function (disable / enable)
Maximum efficiency
85-90%
Nominal power (W)
1500W Models. Maximum power 30
min (W) 1700W.
Maximum power
3 min (W) 2300W.
Maximum power
5 sec (W) 3000W.
Maximum load
Up to short circuit.
Nominal power (W)
3000W Models. Maximum power 30
min (W) 3500W
Maximum power
3 min (W) 4500W
Maximum power
5 sec (W) 6000W
Maximum load
Up to short circuit
Maximum input voltage
265 Vac, 350 V peak
Minimum input
voltage Adjustable 150-230Vac
Input Frequency
range 45~63Hz
Adjustable charging
current:-
1500w versions:-
* 0-50A [ 0-35A ]
3000w versions:-
* 0 - 100A:- [ 0-70A]
*Setting of AC
INPUT current POWER SHARING 0 to 15A
Solar Charge Regulator-Floating.
Maximum Open
Circuit Voltage 25V [ 45V ].
Maximum charging
current 30A
*Low battery disconnection
voltage 10.8V [ 21.6V ]
*Low voltage
10.8V~12.0V (11.6V) [ 21.6V~24.0V (23.2V) ].
*End of charge
cycle voltage 14.2V~15.0V (14.4V) [ 28.4V~30.0V (28.8V) ].
*Equalization
voltage every 25 cycles 15.1V~15.5V (15.3V) [ 30.2V~31.8V (30.6V) ].
*Floating voltage
13.3V~13.7V (13.5V) [ 26.6V~27.4V (27.0V) ].
*Absorption charge
time 0~4h (2h)
Temperature compensation
(Optional) -3mV / C / cell
AC By pass time (UPS-Mode)
20 ms max.
Potential free
Multifunction contact 5Amps -250Vac / 7 Amps - 60V dc x 2.
Max Current at
Transfer relay 15 Amps / AC 220V 30Amps / AC220V.
Operating temperature
-20C to +55C.
Fan forced ventilation
internal sensor From 45C - over 75C will cause trip out.
Protection index
IP IP20.
Net Weight1500W
Models 20.00kg, 3000W Models 28.0kg.
Dimension L*W*H
(mm) 1500W Models:- 350 x 285 x 185, 3000W Models:- 510 x 285 x 185.
MODE OF OPERATION
The low dc voltage is converted into a pure sine wave using solid state power electronic devices, the frequency of the output voltage is crystal controlled for accuracy and stability. The dc input voltage is sampled in order to detect either a low or a high input and generates an alarm signal plus an output drive shutdown. Similarly the internal heat sink temperature is monitored and if a high temperature is detected an alarm signal plus an output drive shutdown occurs until the temperature has dropped to a safe level when the unit will automatically switch back on. The dc input current draw is measured in order to detect an overload, if an overload exists an alarm plus an output drive shutdown is generated. If during the slow start switch on an overload is generated the unit will continue to generate the alarm/shut down signal until the overload is reduced.