X-TRACT INSTALLATION
|
|
|
|
|
Electrical Wiring
Note:-
The wiring to terminal connections are as follows and must be completed
using suitably rated cable, all battery leads should be kept as short as possible.
Overload protection for the input wiring must be installed at source.
It is advisable that all input/output power sources are either
switched off or disconnected prior to installation.
Power input positive:- to the "+IN" terminal block.
Power input negative:- to the "-IN" terminal block.
Power output positive:- to the "+OUT" terminal block.
Power output negative:- to the "-OUT" terminal block.
Fixed on/off via link or remote switch (not applicable to 50A unit).
Mechanical Installation
Mount if possible in a vertical position.
Mount in area not subject to water ingress or high levels of humidity.
Where the unit is fan cooled allow a minimum of 150mm of space around the unit for cooling purposes.
Do not mount near to other equipment which generates high temperature levels.