Notes:
The Alt17 is a 14 volt 110 Amp alternator suitable for or as a replacement alternator on some Volvo and Nanni engines. If replacing lower rating alternators ensure that all cables are capable of handling the higher current capacity. If an electronic charge splitter or mechanical charge splitter is used to provide split charging facility ensure the equipment is capable of handling the increased current capability. The alternator comes with a standard 65 mm pulley suitable for a 12.5 mm belt, other pulley sizes to order at extra cost. If in doubt about the pulley supplied with the new alternator remove the pulley from the original alternator and fit it to the replacement alternator.
To modify this alternator for use with our range of alternator charge controllers will require the alternator to be dismantled as the brush connections are internal to the alternator. For modification details go to the alternator modification page by clicking here, when re-assembling alternator ensure any added cables are not trapped or cause a short circuit.
When installed on certain Volvo engines additional spacers and washers will be required due to the line up of the drive belt. Details of the extra spacer are as follows, O/D 20 mm, I/D **mm, thickness 10mm, material any suitable material (further data will be posted when available). as the majority of Valeo alternators have a 3" pulley it may be necessary to fit existing pulley to replacement alternator to provide correct r.p.m. readings on the tacho.
.
Click here for Contact Information
